Wireless N 300Mbps Access Point / Bridge / Repeater / Router with Gigabit & 802.3af PoE HARDWARE SPECIFICATIONS: MCU: RT2880, 266MHz Memory: 32MB SDRAM Flash: 8MB Physical Interface: LAN One 10/100/1000 Gigabit Ethernet Reset Button Power Jack WPS Push Button (Wi-Fi Protected Setup) LED’s Status: Power (Status) LAN (10/100/1000Mbps) WLAN (Wireless Connection) Power Requirements: Power Supply: 90 to 240VDC ± 10% 50/60Hz (Depends on different countries) Active Ethernet: (Power-over-Ethernet, IEEE 802.3af) 48VDC/0.375A Device: 12V/1A Regulation Certifications: FCC Part 15/UL, CE RF SPECIFICATIONS: Frequency Band: 2.400–2.484GHz Media Access Protocol: Carrier Sense Multiple Access with Collision Avoidance (CSMA/CA) Modulation Technology: OFDM: BPSK, QPSK, 16-QAM, 64-QAM, DBPSK, DQPSK, CCK Operation Channels: 11 for North America Receive Sensitivity (Typical): IEEE 802.11n MCS8 @ -91dBm MCS15 @ -74dBm IEEE 802.11g 6Mbps @ -92dBm 54Mbps @ -75dBm IEEE 802.11b 1Mbps @ -93dBm 11Mbps @ -91dBm Available Transmit Power: IEEE 802.11n/g 19dBm @ 6~9Mbps / MCS9 18dBm @ 12~18Mbps / MCS11 17dBm @ 24~36Mbps / MCS13 16dBm @ 48~54Mbps / MCS15 IEEE 802.11b 18dBm @ 1~11Mbps Antenna: Detachable Omni Antenna x3; RP-TNC Type; Peak Gain 5dBi Impedance: 50ohm Frequency Range: 0~6GHz V.S.W.R.: 1.5 (Max) Working Voltage: <=500Vrms Dielectric Withstanding Voltage: <=1500Vrms Insulation Resistance: >=5000Megohms Contact Resistance: Center contact 1.5Milliohms (Max) / Outer contact 0.2Milliohms (Max) SOFTWARE FEATURES: Topology: Infrastructure Operation Mode: Client Bridge / Access Point / WDS AP / WDS Bridge / Client Router / Router / Universal Repeater LAN: DHCP Server / DHCP Client Wireless: Wireless Mode 802.11b / 802.11g / 802.11n Channel Selection (Setting varies by Country) Signal Strength Bandwidth Selection 40/20MHz Transmission Rate 802.11b/g: 54, 48, 36, 24, 18, 12, 11, 9, 6, 5.5, 2, 1 in Mbps 802.11n Security: WEP Encryption 64/128bits WPA Personal (WPA-PSK using TKIP or AES) WPA Enterprise (WPA-EAP using TKIP) 802.1x Authenticator 802.1x Supplicant MD5/TTLS (Client Bridge & Client Router mode) Hide SSID in Beacons Multiple SSID with 802.1q VLAN Tagging (up to 4 SSID)(Access Point mode) MAC Filter (Access Point mode) WLAN L2 Isolation (Access Point mode) Wireless STA (Client) Connected List QoS: WMM MANAGEMENT: Configuration: Web-Based Configuration (HTTP) / Telnet Firmware Upgrade: Upgrade Firmware via Web Browser; Keep Latest Setting When Firmware Update Administrator Setting: Administrator Password Change Reset Setting: Reboot / Reset to Factory Default System Monitoring: Status, Statistics and Event Log SNMP: v1, v2c MIB: MIB I, MIB II (RFC1213), and Private MIB Traffic Measurement: Per Interface Bandwidth Measurement: IP Range & Bandwidth Management Backup & Restore: Settings Through Web ENVIRONMENT & PHYSICAL: Temperature Range: Operation 0°C to 45°C (32°F to 113°F) / Storage -20°C to 70°C (-4°F to 158°F) Humidity (Non-condensing): 5% ~ 95% Typical Dimensions: L: 4.92” (125mm) x W: 4.25” (108mm) x H: 1.22” (31mm) Weight: 0.77lb. (350g)
Скачать